580F - Rooftops (3 to 12.5 Tons) Bryant > Product Description Index
580F 
Single Package Rooftop
Gas Heating/Electric Cooling Units
3 to 12½ Nominal Tons
Bryant 580F Rooftop Smaller Sizes


The 580F line of packaged rooftop standard-efficiency gas heating units are ideal for both new construction and replacement jobs. Typical applications include school, office, retail, health care, and industrial buildings. All models (except 036, 150 and 151) are available in low, medium, and high heat models.

Every unit is thoroughly run-tested at the factory in each operating mode. This automated testing allows accurate, undisputed tests and measurements which are second to none in the industry. Each unit contains a factory printout - indicating tested pressures, amperages, dates, and inspectors - providing certification of the status at the time of manufacture, under factory conditions.

Underwriters Laboratory Listed ARI Standard ARI Standard
ARI 210 ARI 360

Standard Features:
  • One piece top on all sizes for structural and leak integrity
  • Standard 3, 4, and 5 ton units weigh less than 500 lbs
  • High and Low (loss-of-charge) Pressure Switches and Freezestat
  • Refrigerant filter drier
  • Outdoor ambient cooling operation from 25° F to 115° F
  • Sloped corrosion resistant condensate drain pan with dual drain connections
  • Commercial strength full perimeter roll formed base rails
  • All condenser coils set on rubber isolators to prevent contact with unit base pan, eliminating galvanic corrosion
  • 2-inch disposable air filters are provided standard
  • Tool-less filter access panel
  • Fixed Orifice refrigerant metering system precisely controls refrigerant flow while maintaining optimum unit performance
  • Two speed, direct drive motors standard on 036-060. Belt drive with variable pitch pulley standard on 072-151.
  • Belt drive evaporator-fan motors available on all sizes
  • Industry exclusive solid-state Integrated Gas Controller (IGC) on all models
  • Tubular dimpled heat exchanger enhances heat transfer Alumagard¿ corrosion resistant coating standard
  • Induced draft (negative pressure) combustion
  • Solid-state electronic direct spark ignition lights burners only on call for heating (pilot-less system)
  • Redundant gas valves
  • Flame rollout safety protection
  • Units are designed to be field convertible for both curb (vertical) and slab (horizontal) installation
  • All units are run tested at the factory
  • Low voltage terminal blocks for easy thermostat wiring connections
  • Dual compressors and dual refrigeration circuits on 090-151
  • Compressor vibration isolation mounting
  • Power, control, and gas connections made on same side of unit
  • Through-the-bottom power, control and gas capability
  • Pre-painted corrosion resistant baked enamel finish on inside and outside of cabinet

Factory Installed Options:
  • High Static Motor
  • Convenience Outlet
  • Non-Fused Disconnect Switch
  • Corrosion resistant coil options

Additional Information
Physical Data
Documents/Downloads
Return to Top View Printable Version

Privacy Policy Terms of Use  Bryant is a part of UTC Climate, Controls & Security, a unit of United Technologies Corp.
© United Technologies Corporation 2013